Plumber Bondi Logo

0402 290 290

  • HOME
  • BLOCKED DRAINS
  • HOT WATER
  • EMERGENCY PLUMBING
  • PIPE RELINING
×
  • HOME
  • BLOCKED DRAINS
  • HOT WATER
  • EMERGENCY PLUMBING
  • PIPE RELINING

4 Water Heater Maintenance Tips

Whether we utilize expensive or low-cost ways, all of our appliances need be maintained. These techniques will ensure that our machines function effectively and without causing us any inconvenience. In addition, maintenance is utilized to discover plumbing problems in their early stages, allowing you to inspect and correct them right away. Here are some helpful hints for you to keep in mind:

Drain the tank

Water heater tanks should be drained at least once a year. This is done to remove any sediments that are preventing the burner from boiling the water. This procedure ensures that your machine will run smoothly. Draining our tanks is a low-cost technique to keep the device running.

  • Before you do anything, turn off the water heater.
  • Use a garden hose to connect to the drain valve, which is normally located near the bottom of the tank.
  • Close the water valve to stop the water from pouring into the tank.
  • The relief valve can be unlocked to break the valve.
  • Open the drain valve.
  • Sediments will pour out of the tank after the drain valve is opened. After that, reverse the steps. Make certain that the electricity or gas is turned off before filling the tank with water.

Insulate water heater

Insulating your water heater isn’t just for maintenance; it can also help you save money on your monthly electricity bill. Most people believe that pipes are the only ones that need to be insulated, however this is incorrect. Insulation is also required for our water heater. This will not only lower your bill, but it will also avoid heat loss. Households that utilize new water heater models, on the other hand, are no longer required to use insulation.

Decrease temperature

The temperature of our water heater, according to experts, should be between 115 and 120 degrees Fahrenheit. You will save energy by using this strategy, and your unit will not overheat and explode as a result. In addition, energy usage is reduced. If you use a water heater at home, you should be aware that if the temperature inside the tank becomes too high, your water pipes will likely expand. As a result, the tank will develop cracks and leaks, or worse, burst. With this level of care, you can rest assured that you will never have to deal with crack tanks again.

Replace anode rod

The sacrificial anode rod is another name for this element of our water heater. Brass or magnesium can be used to create the rod. After years of use, the rod will need to be replaced. The reason for this is that water substances generate an electrochemical reaction that causes the component to corrode and become less efficient, even if it is not malfunctioning. If you wish to replace the rod, make sure you get one right away if you don’t want your water tank to look like the rod.

Filed Under: blog, Hot Water

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *

Book a Job

Or Request For Expert Advice
This field is for validation purposes and should be left unchanged.
bondi logo large

Bondi NSW 2026 Australia

Phone : 0402 290 290
Email : i[email protected]

QUICK LINKS

  • Home
  • About Us
  • Testimonials
  • CONTACT US

SERVICES

  • BLOCKED DRAINS
  • HOT WATER
  • EMERGENCY PLUMBING
  • PIPE RELINING

GOT A QUESTION?

© Copyright 2023 Plumbing Service. All Rights Reserved.

Terms & Condition | Privacy Policy

Designed & Developed by: plumber bondi